Article Dans Une Revue Biomass and Bioenergy Année : 2014

A dynamic measurement of a disc chipper cutting forces

Résumé

Nowadays wood chips produced from raw material of inferior quality are mainly used to feed domestic and industrial boilers. For this use, a good chip size distribution and low manufacturing energy consumption are required. Cutting forces are still inaccurately measured during the wood chipping process, which implies the use of oversized chippers' motors. A test bench for chipping wood under reasonably realistic conditions of industrial production is improved by adding an indirect force measurement system with high bandwidth of 3 KHz. The dynamic experimentations give the data needed to compute the curve presenting the vertical component of the cutting force, which is composed of three sections; the first one presents the values of the impact force; the second one is relatively straight and it refers to shear stress in wood; the third section corresponds to the period between two crosscuts.

Fichier principal
Vignette du fichier
JBB-S-13-00404.pdf (1) Télécharger le fichier
Origine Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-04823526 , version 1 (06-12-2024)

Identifiants

Citer

Rémi Georges, Sébastien Auchet, Pierre Jean Méausoone. A dynamic measurement of a disc chipper cutting forces. Biomass and Bioenergy, 2014, 64, pp.269-275. ⟨10.1016/j.biombioe.2014.02.033⟩. ⟨hal-04823526⟩
8 Consultations
7 Téléchargements

Altmetric

Partager

More